Introduction A turnstile is a form of gate which allows one person to pass at a time. It restricts passage only to people who flashes access card or similar. Thus a turnstile can be used in the case of paid access, controlled access or attendance tracking for example to access public transport, a pay toilet, or to restrict access to un-authorized people, for example in the lobby of an office building
Power Supply: AC220V±10V, 50Hz (OR) AC110V±10V, 60Hz.
Temperature: -15 to 60 degree centigrade.
Passage Width: <=600mm Passing Speed: 40 Persons /Min. Optional: Manual/RFID(125 KHZ)/Biometric. Power Consumption: 100W/24V. Input: +12V electrical or impulse signal with width > 100ms, Drive current >10mA.
Communication Interface: USB/GPRS/Wi-Fi/LAN.
Material: Housing- 304 stainless steel, Arm- stainless steel.
Dimension: 420*330*980 mm, Arm Dimension: ￠38*500mm.
Working Environment: Indoors or outdoors with roof cover.
Turnstile arm installation
Step 1: Put arm into its place according to its serial number Screenshot (20)
Step 2: Put a peg into the hole of the arm fixing plate
1. Connect turnstile with AC power.
2. Arm lifting: Press the up arm by force to the lowest place (cannot by lower any more even by force), and then lift it to the level place to let is fixed.
3. Arm falling: Power off, arm drop.
4. Turnstile function testing
Tip1: Never connect any other equipment with the turnstile without permission and make sure the turnstile is reliable ground connected.
Tip2: If turnstile will be used in outdoors, please ensure that it will work on the cement platform with the height of 100mm to 200mm to avoid the dampness. And install the canopy over the turnstile or any other equipment which can protect turnstile from sun and rain. It is not allowed to let the turnstile working in the open air.
Tip3: Never use the turnstile when it is thunderous, it may damage.